[email protected] Free Shipping On Orders Over $40

Shopping Cart

Liquid filter

Overview

Ripples delivers a classic, big-sounding analog four-pole filter in a small 8-HP package, continuing Mutable Instruments lineage of warm and tasty filters started by the Shruthi SMR4 mkII and 4-Pole Mission.

3 filter modes are available: 2-pole band-pass, 2-pole low-pass, and 4-pole low-pass.

Self-oscillation is available for all modes and produces a clean sine-wave on the LP4 output. Unlike many classic 4-pole designs, this filter does not suffer from loudness drop when resonance is increased. The resonance loudness compensation circuit brings a slight tone coloration reminiscent of the Roland SH/Jupiter filters, with a very round and liquid resonance.

The 4-pole low-pass output is additionally sent to a VCA. This makes Ripples a good final stage module for an inexpensive/space-constrained subtractive synthesis synth voice.

Specifications

Inputs

Signal in

Frequency CV 1 (1V/Oct)

Resonance CV. Self oscillation starts at 4V. Control voltages above 5V are non-linearly compressed, for fine control of resonance overdrive

Frequency CV 2 (with bipolar attenuator, from -1V/Oct to 1V/Oct)

VCA level. Control voltages above 5V are non-linearly compressed.

Controls

Cutoff frequency, 18Hz to 18kHz

Resonance (self oscillation at 80%)

Attenuverter on Frequency CV

Outputs

2-pole BP

2-pole LP

4-pole LP

4-pole LP attenuated by VCA

Technical characteristics

Fully analog, based on SSM2164 low noise/distortion quad VCA chip, and LM13700 OTA for that extra bit of non-linearity.

Frequency CV inputs impedance: 100k.

Audio input impedance: 75k.

Resonance and VCA CV input impedance: 30k.

Open-source hardware.

8-HP.

Current consumption: +12V: 35mA ; -12V: 35mA.

Add a Review

Your email address will not be published. Required fields are marked *

Related Products